Grip/Thumb Warmer Adjustment Switch; Auxiliary Dc Jack (Pz50Vt) - Yamaha PZ50RTZ Owner's Manual

1. Headlight beam switch "LIGHTS"
2. High beam "HI"
3. Low beam "LO"
ESU10674
Grip/thumb warmer adjustment
switch
The grip/thumb warmer adjustment switch
controls the electrically heated handlebar
grips and throttle lever.

1. Grip/thumb warmer adjustment switch

To raise the temperature
To raise the grip warmer temperature, press
the " " side of the switch. To raise the thumb
warmer temperature, press the "
the switch.
To lower the temperature
Continue to press the switch until the temper-
ature level returns to the minimum level, and
then raise the temperature to the desired lev-
el.
See "Fuel meter and grip/thumb warmer level
indicator" on page 13 for detailed information.
ESU10691

Auxiliary DC jack (PZ50VT)

The auxiliary DC jack is located in the front
panel and can be used for accessories.
TIP
The auxiliary DC jack cannot be used if the
engine is not running.
To use the auxiliary DC jack
1. Start the engine.
2. Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
1. Auxiliary DC jack cap
2. Auxiliary DC jack
3. After using the auxiliary DC jack, be sure
to remove the accessory power plug from
the jack and to close the auxiliary DC jack
cap.
ECS00120
NOTICE
Do not use accessories requiring more
G
than the maximum rated capacity for the
" side of
auxiliary DC jack. This may overload the
circuit and cause the fuse to blow. (See
page 74 for the specified amperage.)
Do not use an automotive cigarette light-
G
er or other accessory with a plug that
gets hot because the jack can be dam-
aged.
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
Control functions
17