Table of Contents
Advertisement
ESU10676
Grip/thumb warmer adjusting
switch
The grip/thumb warmer adjusting switch con-
trols the electrically heated handlebar grips
and throttle lever.
1
1. Grip/thumb warmer adjusting switch
To raise the temperature
To raise the grip warmer temperature, press
the "
" side of the switch. To raise the thumb
warmer temperature, press the "
the switch.
To lower the temperature
Continue to press the switch until the temper-
ature level returns to the minimum level, and
then raise the temperature to the desired lev-
el.
See "Fuel meter and grip/thumb warmer level
indicator" on page 14 for detailed information.
ESU10696
Auxiliary DC jack (PZ50VT)
The auxiliary DC jack is located in the front
panel and can be used for accessories.
TIP
The auxiliary DC jack can only be used if the
engine is running.
To use the auxiliary DC jack
1.
Start the engine.
2.
Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
1. Auxiliary DC jack cap
2. Auxiliary DC jack
3.
After using the auxiliary DC jack, be sure
to remove the accessory power plug from
the jack and to close the auxiliary DC jack
cap.
ECS00122
NOTICE
" side of
To avoid circuit overload and a possible
G
fuse blowing, do not use accessories re-
quiring more than the maximum rated
capacity for the auxiliary DC jack. (See
page 76 for the specified fuse amper-
age.)
Do not use an automotive cigarette light-
G
er or other accessory with a plug that
gets hot because the jack can be dam-
aged.
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
ESU10551
Brake lever
The snowmobile is stopped by braking the en-
tire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.
Control functions
19
Hide quick links:
Advertisement
Table of Contents
