Drive Select Switch; Engine Stop Switch; Headlight Beam Switch "Lights - Yamaha PZ50RTZ Owner's Manual

Control functions
play. Note the error code, and then have a
Yamaha dealer inspect the snowmobile as
soon as possible. NOTICE: Do not continue
to operate the engine longer than neces-
sary if there is an error code to avoid pos-
sible engine damage.
3
2
1. Warning light "
2. Self-diagnosis warning indicator "
3. Error code display
ESU10544

Drive select switch

The drive select switch is used to shift the
snowmobile into drive or reverse. After com-
ing to a complete stop, press the drive select
switch.
The drive "D" indicator light comes on when
the transmission is in drive (forward).
The reverse "R" indicator light comes on when
the transmission is in reverse.
1. Drive select switch
2. Drive "D" indicator light
3. Reverse "R" indicator light
16
[ECS00820]
"
"
ECS00052
NOTICE
Do not use the drive select switch while
the snowmobile is moving. Otherwise, the
drive train could be damaged.
ESU10531

Engine stop switch " "

The engine stop switch is used to stop the en-
gine in an emergency. Simply push the stop
switch to stop the engine. To start the engine,
pull the stop switch and proceed with starting
the engine. (See page 35 for engine starting
procedures.)
1. Engine stop switch "
During the first few rides, practice using the
stop switch so that you can react quickly in an
emergency.
ESU10661
Headlight beam switch
"LIGHTS"
Push the headlight beam switch to change the
headlight to high beam "HI" or to low beam
"LO".
"