Yamaha PZ50RTZ Owner's Manual page 55

1. Projection on the end of the air filter case
cover
2. Slot in the air filter case
2. Fit the holders on the front cover over the
projections on the air filter case cover,
slide the front cover downward, and then
hook the latch onto the holder on the front
of the snowmobile.
1. Holder on the front cover
2. Projection on the air filter case cover
Shroud and air filter case cover
(PZ50VT)
To open the shroud and remove the air filter
case cover
1. Unhook the shroud latches, and then
slowly raise the shroud forward until it
stops.
Periodic maintenance and adjustment
1. Shroud latch
2. Shroud
2. Loosen the fasteners, lift up the air filter
case cover slightly, and then unhook the
cover from the air filter case to remove it.
1. Air filter case cover
2. Fastener
To close the shroud and install the air filter
case cover
1. Insert the projections on the end of the air
filter case cover into the slots in the air fil-
ter case, place it in the original position,
and then tighten the fasteners.
49