Headlight Beam Switch "Lights; Grip/Thumb Warmer Adjustment Switch; Auxiliary Dc Jack (Pz50Vt) - Yamaha PZ50RTX Owner's Manual

ESU10661
Headlight beam switch
"LIGHTS"
Push the headlight beam switch to change the
headlight to high beam "HI" or to low beam
"LO".

1. Headlight beam switch "LIGHTS"

2. High beam "HI"
3. Low beam "LO"
ESU10670
Grip/thumb warmer adjustment
switch
The grip/thumb warmer adjustment switch
controls the electrically heated handlebar
grips and throttle lever.

1. Grip/thumb warmer adjustment switch

To raise the temperature
To raise the grip warmer temperature, press
the " " side of the switch. To raise the thumb
warmer temperature, press the "
the switch.
To lower the temperature
Continue to press the switch until the temper-
ature level returns to the minimum level, and
then raise the temperature to the desired lev-
el.
ESU10690

Auxiliary DC jack (PZ50VT)

The auxiliary DC jack is located in the front
panel and can be used for accessories.
NOTE:
The auxiliary DC jack cannot be used if the
engine is not running.
To use the auxiliary DC jack
1. Start the engine.
2. Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
1. Auxiliary DC jack cap
2. Auxiliary DC jack
NOTE:
After using the auxiliary DC jack, be sure to
remove the accessory power plug from the
jack and close the auxiliary DC jack cap.
ECS00120
CAUTION:
Do not use accessories requiring more
G
than the maximum rated capacity for the
" side of
auxiliary DC jack. This may overload the
circuit and cause the fuse to blow. (See
page 69 for the specified amperage.)
Control functions
17