Tool Kit; Removing And Installing The Shroud And Covers - Yamaha PZ50RTZ Owner's Manual

Periodic maintenance and adjustment
ESU13001

Tool kit

The service information included in this man-
ual and the tools provided in the owner's tool
kit are intended to assist you in the perfor-
mance of preventive maintenance and minor
repairs. However, additional tools such as a
torque wrench may be necessary to perform
certain maintenance work correctly.
1. Tool kit
ECS00780
NOTICE
Before starting the engine, make sure that
the tool kit is securely fastened (PZ50RT /
PZ50GT / PZ50MT) and that the storage
pouch zipper is completely closed.
TIP
If you do not have a torque wrench available
during a service operation requiring one, take
your snowmobile to a Yamaha dealer to
check the torque settings and adjust them if
necessary.
ESU11764
Removing and installing the
shroud and covers
EWS00091
WARNING
Be sure shroud and covers are secured
before operation. A loose shroud or cover
could move and cause loss of control.
48
Front cover and air filter case cover
(PZ50RT / PZ50GT / PZ50MT)
To remove the front cover and air filter case
cover
1. Unhook the latch, and then slide the front
cover upward.
2
1. Latch
2. Front cover
2. Loosen the fasteners, lift up the air filter
case cover slightly, and then unhook the
cover from the air filter case to remove it.
2
1
1. Air filter case cover
2. Fastener
To install the front cover and air filter case
cover
1. Insert the projections on the end of the air
filter case cover into the slots in the air fil-
ter case, place it in the original position,
and then tighten the fasteners.
1