Assembly And Initial Set-Up; Step 1. Inspect & Unpack; Step 2. Assembly; Step 3. Verify Electrical Connection - North Star M157305Y Owner's Manual

Step 1. Inspect & Unpack
Inspect pressure washer immediately after delivery for
missing parts or damage. Find and separate
components identified in Figure 4 and Figure 5.
 For missing or damaged components, contact Product
Support at 1-800-270-0810.
Spray
Gun
Qty-1
Figure 4 – Pressure Washer Components
Wheel
Retainers
Qty-2
Gun
Hooks
Qty-2
5/16 Nut
Qty 5
Figure 5 – Parts to be Installed

Assembly and Initial Set-Up

High Pressure Hose
Qty-1
Manual Bag
Qty-1
Pressure
Washer
Qty-1
Wheel
Qty-2
Nozzles
Qty-6
Hose
Hooks
Qty-3

Step 2. Assembly

Insert nozzles in spaces provided on the control panel.
To install wheels, refer to Figure 6:
Raise pressure washer off floor using blocks or

ramps and secure.
Install two wheels with grease zerk away from

frame.
Slide wheel retainers onto end of each axle.

Tighten retainer setscrew with a hex wrench.
Axle
Wheel
 Install hose hook and gun hooks in the following
locations fasten with nut:
Gun Hooks

Step 3. Verify Electrical Connection

Grounding

Product must be grounded. The supply cord is equipped
with an equipment-grounding conductor and a
grounding plug. This plug must be plugged into an outlet
that is properly installed and grounded in accordance
with all local codes and ordinances.

Ground Fault Circuit Interrupter Protection

Connecting the pressure washer through some type of
ground fault circuit interrupter (GFCI) protector is
required to comply with the National Electric Code
11
Wheel
Retainer
Grease Zerk
Figure 6
Hose Hooks