Assembly And Initial Set-Up; Step 1. Inspect & Unpack; Step 2. Assembly; Step 3. Initial Pump & Motor Preparation - North Star M1574210J Owner's Manual

Step 1. Inspect & Unpack
Inspect the pressure washer immediately after you
receive delivery for missing parts or damage. Find and
separate components identified in Fig.1574210_3 and
Figure 1574210_4.
For missing or damaged components, contact Product
•
Support at 1-800-270-0810.
Hardware Bag
High Pressure Hose
Qty-1
799880
Fig.1574210_3
Pressure Washer
Fig.1574210_3 – Pressure Washer Components
Fig.1574210_4 – Parts to be installed

Assembly and Initial Set-Up

Handle Weldment
Qty-1 Spray Gun
800080 Qty-1
777420
Only For 1574213
Lance
Qty-1
777421
Spray
Gun
Qty-1
779165
Lance
Qty-1
791278

Step 2. Assembly

You must assemble your pressure washer before it can
be used. Refer to Fig.1574210_5 and follow the steps
listed below:
Install handle with six (6) 5/16"-18 x 3/4" Flange
•
bolts through base and handle and secure with
six (6) 5/16"-18 Flange bolts.
Install Hose Hook into right side of handle using
•
two (2) M8 Nuts.
Install GFCI Cord Hook into right side of handle
•
using two (2) M8 Nuts.
Install Nozzles into designated nozzle storage
•
location.
INSTALL
NOZZLES
INTO
DESIGNATED
NOZZLE
STORAGE
LOCATION
Step 3. Initial Pump & Motor Preparation

Prepare Water Pump

Verify pump oil level. Refer to Fig.1574210_6J and
follow the steps listed below.
NOTE: The Pump is shipped with oil.
Remove shipping tape and black vent plug (if
•
present) from oil fill cap.
Verify that oil level is halfway up the sight glass.
•
If oil level is low, use the oil type from above
•
table. See page no. 5.
11
INSTALL GFCI CORD
HOOK
INTO HANDLE
USING TWO (2)
M8-1.25
NYLOC NUTS
INSTALL HOSE
HOOK
INTO HANDLE
USING TWO (2)
M8-1.25
NYLOC NUTS
5/16-18 X
3/4" SIX
(6)
FLANGE
BOLTS
5/16-18 X
3/4" SIX
(6)
FLANGE
NUTS
Fig.1574210_5