Event; Beeper/E-Mail Setup; E-Mail Registration; Smtp Mode - Vista Quantum XTRA Installation And User Manual

Table of Contents

5. Event

This menu is used to inform the user as to an event occurring, this can be by the sounding of

a buzzer or by sending an E-mail to a predefined address.

Beep Out

The buzzer can be set to sound on the following occurrences: Video Loss, Alarm input,

Motion detection, Power Loss.

The duration of the beep can be set (1~999 seconds or continuous).

E-mail Out

As well as e-mail on event activations the DVR can be set to send a report on the following

occurrences: Video Loss, Alarm, Motion, Power Loss.

Within this section up to 3 users can be set-up to receive an email on the occurrence of an

event such as Video Loss / Alarm / Motion or Power Loss. An E-mail will only be sent if the

DVR is sitting on a network with access to the Internet, e.g. through a router.

The user name & e-mail address are set from the on screen keyboard via the mouse.

The Sender Address is the address that will appear on the E-mail received by the user, this

should be set logically to identify the specific DVR.

The report period is used to set how often e-mails are sent: Immediately, Daily or Weekly.

Send Test Mail" sends a test E-mail to the addresses so allowing the installer to verify if

the setup is correct

The SMTP(Simple Mail Transfer Protocol) function allows e-mails to be sent over a LAN.

The default is SMTP Mode "OFF".

In order to activate SMTP Mode, choose SMTP Mode either IP or Domain first.

Then, put ID, Password, Domain/IP, and port.

Finally press "SMTP Status Check" to test.

Vista QXTRA User and installation manual V1.0

Table of Contents