because there will be two hours of recorded video during this time period. To
view video during this overlapping time period, you must start playback before 1
am, then recorder will play both hours between 1 am and 2 a.m. You cannot do
a backward search through the overlapping time. But, you can do forward
search.
Video Type ( )
Video Type can set in this menu without rebooting or initialisation. The default is PAL, NTSC
can also be selected.
VGA Resolution ( )
The VGA monitor out put resolution can be set to suit the monitor being used
Remote control ID ( )
The remote control can be used to control up to 16 DVRs,
the ID number on each can be set to a unique address so
that the remote will only control one at a time if they are in
close proximity. The default is 11.
To select a unit on the remote control press the ID button,
followed by the number, followed by the ID button again.
The LED will flash slowly.
Key Beep ( )
The buzzer can be set to sound on whenever the button on the front panel or remote
controller is pressed.
Relay time ( )
The time that the relays is active for can be set
PTZ control ( )
The setting for the serial PTZ output control can be set
Initialisation ( )
All the menu settings will be returned to the factory default. To carry out this function the
system recording will have to be turned off.
Disk Format ( )
Formatting of the drive is used when new drives are installed or you need to wipe all
information on the disk.
Vista QXTRA User and installation manual V1.0
48
LED