Plugging In Avaya B189 Conference Ip Phone - Avaya B189 Installing And Maintaining

has limited functionality. For information about unnamed registration, see
unnamed registration
11. Verify that a Category 5e LAN jack is available at each phone site and a Category
5 modular line cable that connects the deskphone to the LAN jack. Cat 5 cables
with an RJ45 plug have a plug size restriction of 36 mm.
12. Verify that each deskphone receives power through a Telephone Power Module
or a POE switch. For PoE Input connection, use only with UL listed I.T.E.
equipment with PoE output. If LAN supplies IEEE-standard power, or Power over
Ethernet, to the deskphone, the phones do not require a power module. PoE must
support Class 3.

Plugging in Avaya B189 Conference IP Phone

Caution:
Use the correct jack when you plug in the phone. You can find the jacks at the rear of the
phone housing. Flip the cover to see the connecting jacks. Icons on the side of the jacks
represent the correct use of each
Procedure
1. Plug one end of the CAT5 cable into the corresponding jack in the phone.
2. Connect the other end of the CAT5 cable to the wall connector as show in the
Installing and maintaining Avaya B189 Conference IP Phone
on page 20.
following figure.
Plugging in Avaya B189 Conference IP Phone
About
January 2014 13