Out Of Range; No Remote Output; Feature Not Available - Viper 5706V Owner's Manual

Out of Range

Each time a command is performed the remote will expect a com-
mand confirmation from the system. If a command confirmation is not
received the out-of-range icon (
alert.

No Remote Output

Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command
was corrupted due to local RF interference). These are temporary nor-
mal functions of the system and remote, perform the command again
within 10 seconds to return to normal operation.

Feature not Available

The
NOT AVAILABLE
and solution depending upon the command used:
Command
Runtime Reset
Sensor Bypass
Defroster
42 42
message is a generic one which varies in cause
Cause
Remote Start is Off
System is not armed
Remote Start is Off.
Not configured for
this.
) and a fault tone will play as an
Reason/Solution
Only available when Remote Start is On
Only available when system is armed
Only available when Remote Start is On.
Only available when configured for
Defroster control.
© 2013 Directed. All rights reserved.