Car Select; Out Of Range; No Remote Output - Viper 4806V Owner's Manual

Car Select

Car 2 remote control option must first be turned On (See Remote Con-
trol Configuration section to turn on).
Press and hold the
1.
or twice to indicate the selected Car is 1 or 2.
Release the button for Car Select or continue to hold for program-
2.
ming.
Release the
3.
flashes continue to perform Car Select. Once the car is selected
a command can be performed by pressing one of the command
buttons.

Out of Range

Each time a command is performed the 2-way remote will expect a
command confirmation from the system. if a command confirmation is
not received a fault tone will play as an alert.

No Remote Output

Occasionally when a command is performed, the output of the remote
control may not generate a command confirmation output or out of
range output. This indicates that the system received the command
but it was an incomplete command (e.g. the command was corrupted
due to local RF interference). These are temporal nuances of the sys-
tem and remote, perform the command again within 10 seconds to
return to normal operation.
30
AUX
button for 3 seconds. The LED flashes once
AUX
button, then press and release while the LED
© 2016 Directed. All rights reserved.