IBM Flex System FC3171 Installation And User Manual page 38

4. At the login prompt, type the management-module user name (Windows only).
5. Press Enter.
6. At the login prompt, type the management-module user name. At the password
7. Type admin start and press Enter to obtain administrator privileges.
8. Normally, the date and time are set by the CMM through NTP. However, as an
9. Type admin end and press Enter to exit from the administrator operating mode
Note: For more information about password requirements and using the CLI, see
the applicable documentation that is listed in "CLI command format" on page 30.
28
IBM Flex System FC3171 8 Gb SAN Switch and Pass-thru Installation and User's Guide
At the password prompt, type the management-module password. The user
name and password are case sensitive and are the same as those that are used for
management-module Web access. The default management-module user name is
USERID, and the default password is PASSW0RD. (Note that the sixth character in
PASSW0RD is the number zero (0), not the letter O.).
The Command Line Interface Shell window opens.
A command-prompt window opens.
prompt, type the management-module password. The user name and password
are case sensitive and are the same as those that are used for
management-module Web access. The default management-module user name is
USERID, and the default password is PASSW0RD. (Note that the sixth character in
PASSW0RD is the number zero (0), not the letter O.)
The Command Line Interface Shell window opens.
option, you can set the date and time of the switch by typing date
[MMDDhhmmCCYY] where:
[MM] is the month
[DD] is the day
[hh] is the hour in 24-hour format
[mm] is the minute
[CC] represents the century identifier
[YY] represents the last two numbers of the year
For example, the format for 28 March 28 2011 8:46 p.m. is date 032820462011.
Press Enter.
and return to the standard operating mode.