Power Requirements - Jacuzzi ProTech Owner's Manual

5.0 Power Requirements

Jacuzzi Premium spas are designed to provide optimum performance and flex-
ibility of use when connected to the maximum electrical service listed in the
tables below. If you prefer, your dealer can perform a minor circuit board
modification to allow your spa to accept an electrical service other than the
factory setting.
US / Canada J-310 1-Pump Convertible Model (60Hz)
Voltage:
# of Wires:
Frequency:
Current Draw:
Circuit Breaker:
For 240 VAC Heater Operation: Move the red wire on the main terminal
strip (TB1) from position #1 to position #3. Make certain wires are connect-
ed exactly as shown in Figure-D (Page 12) before applying power. Failure to
do so will result in damage to the circuit board and/or related components
and void the manufacturer's warranty.
* In the 15A/30A configuration, the heater will not operate at the same
time as the high-speed jets pump. The factory setting is 120V/15A.
** If the spa is to be operated on 40A service, remove the jumper JP1
#1-2 on the circuit board to allow the heater to operate at the same
time as the high-speed jets pump (Page 38).
US / Canada J-320 / J-330 1-Pump Models (60Hz)
Voltage:
# of Wires:
Frequency:
Current Draw:
Circuit Breaker:
* In the 50A configuration, the heater will operate at the same time as the
high-speed jets pump. This is the factory setting.
** In the 30A configuration, the heater will not operate at the same time as
the high-speed jets pump.
Page 8
120V/15A*
120 VAC
3 (15A GFCI Cord)
60Hz
12A
15A, 1-Pole
240V/50A*
240 VAC
3
60Hz
34A
50A, 2-Pole
240V/30A*
240 VAC
4
60Hz
21A
30A, 2-Pole
240V/30A**
240 VAC
3
60Hz
24A
30A, 2-Pole
240V/40A**
240 VAC
4
60Hz
30A
40A, 2-Pole