Starting Up; Switching On The Printer - Intermec EasyCoder F2 User Manual

Bar code label printer ipl version

Hide thumbs Also See for EasyCoder F2:

Table of Contents

Chapter 3

Starting Up

Before switching on the printer, make the necessary connections

and check that the printhead is engaged.

Switch on the power using the On/Off switch on the rear plate.

The "Power" control lamp on the front panel lights up when the

power is on. Wait for a few moments, while the printer loads the

program and runs some self-diagnostic tests.

While the printer is initialized, the progress of the initialization

is indicated by an increasing number of colons on the lower line

in the display:

Initializing

:::

When the initialization is completed, a label is fed out. Then

the following message appears, indicating that the printer is ready

for operation:

IPL Ver 1.3

9600-8-N-1-X/X

The upper line indicates the IPL version number and lower line

shows the either the present serial communication setup or an

error message:

- Paused

- Printhead Up

- Press Feed

- Paper Out

- Ribbon Out

- Printhead Hot

Intermec EasyCoder F2 – User's Guide

Table of Contents