Intermec EasyCoder F2 User Manual page 48

Chapter 7 Setup Mode
Setup Mode Overview, Part 4
Continued from the previous page If an optional an EasyLAN 100i interface board
is installed in the printer
SETUP:
NETWORK
• Press <Setup> to exit the Setup Mode.
46
NETWORK:
IP SELECTION
IP SELECTION:
MANUAL
DHCP
BOOTP
RARP
NETWORK:
IP ADDRESS
NETWORK:
NETMASK
NETWORK:
DEFAULT ROUTER
Intermec EasyCoder F2 – User's Guide
Use <.> and <0> - <9>
IP ADDRESS:
to set IP address.
192.168.1.79
Use <C> to erase.
Use <.> and <0> - <9>
NETMASK:
to set netmask.
255.255.255.0
Use <C> to erase
Use <.> and <0> - <9>
DEFAULT ROUTER:
to set default router.
192.168.1.1
Use <C> to erase.