Weber SUMMIT 425 Step-By-Step Manual page 4

MOUNT REGULATOR
BRACKET
You will need: two 1/4-20 x 1/2 inch bolts, two nylon
washers, two 1/4-20 keps nuts, and a 7/16 inch or open
end wrench.
Position the top of the regulator bracket over the top
crosspiece. Slip a washer over bolts and insert through
top of bracket and crosspiece. Add keps nut. Tighten.
Figure 3.
View from front
underside
ADD RIGHT PANEL
FOR THE SUMMIT 450
You will need: right panel.
Remove the bolt and nut holding the tank panel in place
at the bottom. Figure 4 (a). Hold the hose and regulator
up and out of the way. Set the right panel in place, with
the hose and regulator on the outside of the panel.
Tank
panel
Figure 3
Hose and
regulator
(a)
Figure 4
Reinstall the bottom bolt through the right panel and the
tank panel. Add the keps nut and tighten. Either open the
right door or reach underneath the cart to install the keps
nut. Figure 5 (a).
Note: If the tank panel does not stay in place during the
assembly of the right panel, reinstall the tank panel
before installing the right panel.
CAUTION: Make sure the tabs of the tank panel are in
the slots of the top support. Figure 5 (b).
(b)
View from inside
4
(a)
Slots
Tabs
Figure 5