Weber SUMMIT 425 Step-By-Step Manual page 3

REMOVE PACKAGED
CONTENTS (CONTINUED)
Drip pan
Bottom wire rack
(For the Summit 450 only)
Stainless steel bottom shelf (2)
(For the Summit 425 only)
Stainless steel work surface (2)
Condiment holder (2)
Tool holder (4)
Tank scale
LP tank
1/4-20 keps nut (2)
ADD COOKING MODULE
Caution: Use two people to lift and install the
cooking module.
Lift the cooking module out of the packaging. The gas
line, regulator, and bracket will hang below the module.
Lower the module on an angle into the cart so the control
panel is under the front top frame rail. Figure 1. Guide the
gas line regulator and bracket while lowering the module
into the cart.
Lower the back of the cooking module down so it is
between the two flanges in the back panel. Figure 2.
Use caution not to scratch the paint of the cooking
module when setting the module between the flanges.
The cooking module should be level, setting on the front
and rear top frame rails.
Front top
frame rail
3
Flange
View from
Figure 1
Flange
Rear top
frame rail
View from
Figure 2
right
right