Weber SUMMIT 425 Step-By-Step Manual page 13

CHECK FOR GAS LEAKS
(CONTINUED)
DANGER
Do not use an open flame to check for gas
leaks. Be sure there are no sparks or open
flames in the area while you check for
leaks.This will result in a fire or explosion
which can cause serious bodily injury or
death and damage to property.
WARNING: You should check for gas leaks every time
you disconnect and reconnect a gas fitting.
You will need: a soap and water solution and a rag or
brush to apply it.
Note: Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
WARNING: Make sure all burner control knobs are in
the OFF position, including the side burner, if the
barbecue has a side burner.
Turn on gas supply by turning the tank valve handwheel
counterclockwise.
a)
Manifold
Manifold
Figure 25
b)
c)
Check for leaks by wetting the connections with the soap
and water solution and watching for bubbles. If bubbles
form or if a bubble grows there is a leak.
WA R N I N G: Do not ignite bu r n e rs while ch e cking for leaks.
Check:
a) Left valves to manifold connection. Figure 25 (a).
b) Right valves to manifold connection. Figure 25 (b).
c) Gas line to manifold connection. Figure 25 (c)
WARNING: If there is a leak at connection 25 (c) turn
OFF the gas and retighten the fitting with a wrench
and recheck for leaks with soap and water solution.
If a leak persists after retightening the fitting, turn
OFF the gas. DO NOT OPERATE THE BARBECUE.
Contact your dealer.
a) Hose to regulator connection. Figure 26 (a).
b) Regulator to tank connection. Figure 26 (b).
WARNING: If there is a leak at connections
25 (a), 25 (b), 26 (a), or 26 (b) turn OFF the gas.
Do not operate the barbecue. Contact your dealer.
When leak checks are complete, turn gas supply OFF at
the source and rinse connections with water.
a)
13
Figure 26
b)