Sharp AR-M355N Quick Reference Manual page 9

Simulation List (Main/Sub) (cont'd)
26 3 Used to set the specification of the auditor. Setting must be made according to the auditor use conditions.
5 Used to set the count mode of the total counter and the maintenance counter.
6 Used to set the specifications (paper, document detection, etc.) of the destination.
10 Used to set the network scanner trial mode.
18 Used to set YEZ/NO of toner save operation. (This function is valid only in Japan and UK versions. [Depends on the destination
setting of SIM26-6.] For the other destinations, the same setting can be made by the user program P22.)
30 1 Used to check the operation of sensors and detectors in other than the paper feed section and the operations of the related
circuits.
2 Used to check the operation of sensors and detectors in the paper feed section and the related circuits.
40 1 Used to check the operation of the manual feed tray paper size detector and the related circuit. (The operation of the manual
feed tray paper size detector can be monitored with the LCD display.
2 Used to adjust the manual paper feed tray paper width detector detection level.
7 Used to enter the manual paper feed tray paper width adjustment value.
11 Used to check the multi-purpose tray width detection adjustment value.
12 Used to check the multi-purpose tray width detection adjustment value.
41 1 Used to check the operation of the document size sensor and the related circuit. (The operation of the document size sensor
can be monitored with the LCD display.)
2 Used to adjust the document size sensor sensing level.
3 Used to check the operation of the document size sensor and the related circuit. (The document size sensor output level can be
monitored with the LCD display.)
43 1 Used to set the fusing temperature in each operation mode.
44 1 Used to set enable/disable of correction operations in the image forming (process) section.
9 Used to check the data related to the image forming section correction (process correction) result (corrected main charger grid
voltage, the developing bias voltage, and the laser power voltage in each print mode). (This simulation allows to check that
correction is performed normally or not.)
14 Used to check the output level of the temperature sensor and the humidity sensor.
Quick Reference Guide: AR-M355N/M455N
Simulation List (Pg. 4 of 10)
9