Sharp AR-M355N Quick Reference Manual page 11

Simulation List (Main/Sub) (cont'd)
46 39 Used to adjust sharpness of the FAX mode.
45 Used to adjust the image density in the FAX mode (600dpi).
46 Used to adjust sharpness of the scanner mode.
48 1 Used to adjust the copy magnification ratio (in the main scanning and the sub scanning directions).
5 Used to adjust the copy magnification ratio in the sub scanning direction.
6 HSYNC cycle adjustment.
50 1 Used to adjust the copy image position and the void area (image loss) adjustment on print paper in the copy mode. (The similar
adjustment can be performed with SIM 50-5 and 50-2 (Simplified method].) (Document table mode.)
2 Used to adjust the document scan position, the image print position, and the void area (image loss). (Simple adjustment) (This
adjustment is the simple method of SIM 50-1.) (Document table mode.)
5 Used to adjust the print image position and the void area (image loss) on print paper. (Adjustment as the print engine.) (This
adjustment is reflected on all the FAX/printer/copy modes.)
6 Used to adjust the copy image position and void area (image loss) on print paper in the copy mode. (The similar adjustment can
e performed with SIM 50-7 [simple method].) (SPF mode).
7 Used to adjust the copy image position and void area (image loss) on print prepare in the copy mode. (The similar adjustment
can be performed with SIM 50-6). (SPF mode.)
10 Used to adjust the print image off-center position. (Adjusted separately for each paper feed section.)
12 Used to adjust the scan image off-center position. (Adjusted separately for each scan mode.)
27 Used to adjust the image loss of the scan image in the FAX/scan mode.
51 2 Used to adjust the contact pressure of paper on the resist roller of each section (each paper feed, duplex feed and SPF paper
feed of the copier). (This adjustment is required when the print image position variations are considerably great or when paper
jams occur too frequently.)
53 6 Used to adjust the DSPF width detection level.
7 Used to enter the SPF width detection adjustment value.
8 Used to adjust the document scan start position. (Used to adjust the scanner scan position into eh SPF mode front scan.)
Quick Reference Guide: AR-M355N/M455N
Simulation List (Pg. 6 of 10)
11