Sharp AR-M355N Quick Reference Manual page 13

Simulation List (Main/Sub) (cont'd)
65 1 Used to adjust the touch panel (LCS display section) detection position.
2 Used to check the result of the touch panel (LCD display) detection position adjustment. (The coordinates are displayed.)
66 1 Used to change and check the FAX soft switch functions. (Used to change and check the functions provided for the FAX soft
switches.) (Only when FAX is installed.)
2 Used to clear the FAX soft switch function data and to set to the default. (Excluding the adjustment values.) (Only when FAX is
installed.)
3 Used to check the operation of the FAX PWB memory (read/write). (This adjustment is required when the PWB is replaced with
a new one.) (Only when FAX is installed.)
4 Used to check the output operation of data signals in each data output mode of FAX. (Used to check the operation of MODEM.)
Send level: Max. (Only when FAX is installed.)
5 Used to check the output operation of data signals in ach data output mode of FAX. (Used to check the operation of MODEM.)
An output is sent at the send level set by the soft switch. (Only when FAX is installed.)
6 Used to print the confidential pass code. (Used when the confidential pass code is forgotten.) (Only when FAX is installed.)
7 Used to print the mage memory data (memory send/receive). (Only when FAX is installed.)
8 Used to check the output operation of various sound signals of FAX. (Used to check the operation of the sound output IC.)
Send level: Max. (Only when FAX is installed.)
9 Used to check the output operation of various sound signals of FAX. (Used to check the operation of the sound output IC.) An
output is sent at the send level set by the soft switch. (Only when FAX is installed.)
10 Used to clear all data of the image memory (memory send/receive). The confidential data are also cleared at the same time.
(Only when FAX is installed.)
11 Used to check the output operation of FAX G3 mode 300bps. (Used to check the operation of MODEM.) Send level: Max.
(Only when FAX is installed.)
12 Used to check the output operation of FAX G3 mode 300bps. (Used to check the operation of MODEM.) An output is send at
the send level set by the soft switch. (Only when FAX is installed.)
13 Used to enter (set) the number of FAX dial signal output test. (The dial number set by this simulation is outputted when the dial
signal output test is made by SIM 66-14-16.) (Only when FAX is installed.)
14 Used to set the make time in the FAX pulse dial mode (10pps) and to test the dial signal output. (The dial number signals et by
SIM 66-13 is outputted.) Used to check troubles in dialing and to check the operation. (Only when FAX is installed.
Quick Reference Guide: AR-M355N/M455N
Simulation List (Pg. 8 of 10)
13