Auto Mode; Enabling/Disabling Auto Mode; Configuring Auto Mode Frequency Points - Kenwood TS-990S Instruction Manual

AUTO MODE

Auto Mode is a convenient function allowing you to
automatically switch to the correct operating mode
according to your band plan.
You can preconfigure the auto mode frequency points and
the corresponding operating modes. This enables you to
automatically switch the operating mode when tuning from
one auto mode frequency range into another.

ENABLING/DISABLING AUTO MODE

1 Press [MENU].
2 Press [A.MODE] (F1) to open the Auto Mode screen.
3 Press [A.MODE] (F1) to toggle the Auto Mode
between active and inactive.
While Auto Mode is active, the key guide is yellow regardless
of whether or not the key is operable. While Auto Mode is
inactive, the key guide is white.
4 Press [OK] (F6).
5 Press [MENU] to exit.
Contents Index

CONFIGURING AUTO MODE FREQUENCY POINTS

You can configure up to 32 auto mode frequency points.
1 Press [MENU].
2 Press [A.MODE] (F1) to open the Auto Mode screen.
3 Rotate the Tuning control to select the frequency point.
4 Press or press and hold one of mode keys to select the
mode you wish to store.
5 Press [COPY] (F4) to copy the frequency and
operating data.
• The selected band frequency point and mode are stored.
• To delete a stored frequency point and mode, press
[ ] (F2) or [
CH control to select the row to delete, then press
[DELETE] (F5). The points listed below the deleted point
will move up, and the display will refresh.
6 Repeat steps 3 to 5 until frequency and operating data
are configured for all points.
7 Press [OK] (F6).
8 Press [MENU] to exit.
BASIC OPERATIONS 4
] (F3), or rotate the MULTI/
4-11