BBQ GSF2818KM Owner's Manual page 10

Step 8 (Doors assembly)
a) Insert the bottom pin of left door (N)
into the pre-drilled hole on the cart
bottom panel.
b) Push down the top pin of left door
insert it into the pre-drilled hole on
the left end of cart front beam.
c) Repeat the procedure for the right
door (O) assembly.
d) Close the two doors.
Step 11 (Assemble the side bar tool hanger to the side shelves
a) Turn over the left side shelf (D).
b) Align the holes on the end of one side bar tool hanger (C) with the
holes on the left side shelf (D).
c) Insert one bolt (AA), one spring washer (CC) and one flat washer
(BB) into each pre-drilled hole. Tighten bolts by hand until secured.
d) Go back and tighten all bolts using the screwdriver provided.
e) Repeat the procedure for the assembly of right side shelf (V) and
another one side bar tool hanger.
GSF2818KM
Owner's Manual
and
9
Step 9 (Assemble the body to the cart)
a) Put the body assembly (S) on the top of cart
assembly.
b) Align the two holes on the top of cart right side
panel with the two holes on the right of body
assembly.
c) Insert one bolt (AA) with one spring washer (CC)
and one flat washer (BB) into each pre-drilled hole.
d) Tighten bolts by hand until secure.
e) Repeat the procedure for the left end assembly.
f) Go back and tighten all bolts using the screwdriver
provided.
Attention:
Unpack the regulator/hose
assembly (located underneath the firebox)
prior to assembling the grill body to the cart,
and pull out the regulator/hose to the cart
side panel when go ahead to this step.
.
Step 10 Cable assembly
a) Insert the male terminal into the
female terminal and then put the cable
on the clamp pre-installed on the left
side panel and back panel.