HP StorageWorks N1200 User Manual page 61

Figure 25: SCSI Device Override screen
Network Storage Router N1200 User Guide
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change and
verify the desired setting. HP recommends backing up the router configuration
to an external file before making changes to this setting.
The current map can be set to:
— Indexed
— Auto-assigned (default) contains all the devices attached to the router.
— SCC
For more information about mapping modes, see Appendix C,
Methods and Table Structures" on page 169.
For information on changing map entries, see
Override Settings (service mode-restricted access) To override the settings of
a SCSI target, select a Target ID icon with the appropriate Target ID number.
After a specific Target is selected, the SCSI Override sub-screen is displayed
and is used to enter the Override settings (see
SCSI bus override settings:
— CDB Length Override enables or disables the override of default CDB
lengths.
— CDB Group 6 Length Default (default: 0) can be set to 0, 6, 10, or 12.
— CDB Group 7 Length Default (default: 0) can be set to 0, 6, 10, or 12.
— Wide Negotiation enables or disables negotiation on a wide SCSI bus.
Visual Manager User Interface
"Addressing
"Mapping Menu" on page 64.
Figure 25).
61