HP StorageWorks N1200 User Manual page 105

Note:
for Reset-to-Selection Time. HP recommends setting the value to at least 2 seconds to
ensure all SCSI devices complete their individual power on self tests (POST.)
Network Storage Router N1200 User Guide
This value should be set to no less than 250ms, according to the SCSI standard
5) Set SCSI Termination Mode enables or disables the SCSI termination
mode.
6) Edit SCSI Target Override Settings changes the SCSI Target overrides.
SCSI Parameter Override Configuration Menu options:
— 1) Toggle CDB Length Override: enabled or disabled.
If enabled, the following configuration options are displayed:
CDB Group 6 Length Default (default = 0) can be set to 0, 6, 10, or 12.
CDB Group 7 Length Default (default = 0) can be set to 0, 6, 10, or 12.
— 2) Toggle Wide Negotiation: enabled or disabled.
— 3) Toggle Synchronous Negotiation: enabled or disabled.
If enabled, the following configuration options are displayed:
Synchronous Period (default = 40) is the maximum number of seconds
allowed for negotiation.
Synchronous Offset (default =16) is the maximum variation in transfer
rate that can be negotiated in MB/s.
— 4) Toggle Synchronous Parameter Override: enabled or disabled.
7) Enable/Disable Buffered Tape Writes (default: Enabled) enables or
disables Buffered Tape Writes.
Buffered Tape Writes return status on consecutive write commands before the
tape device receives data, to enhance performance.
8) Change Default Map Value sets the default map to use for the bus.
Mapping modes can be Auto-Assigned (default), Indexed, or SCC.
For more information about addressing methods, see Appendix C,
"Addressing Methods and Table
<Enter> scrolls to the next SCSI bus.
Structures" on page 169.
Serial/Telnet User Interface
105