HP StorageWorks N1200 User Manual page 58

Visual Manager User Interface
Note:
receive Framing errors due to the incorrect Fibre Channel link speed.
58
Buffered Tape Queue Depth sets the Buffered Tape Queue Depth.
Select a setting of 0 through 10 from the drop-down list.
Default Map (default: indexed) sets the current mapping mode for the
selected port.
The current map can be set to:
— Indexed (default)
— Auto-assigned contains all the SCSI devices that are attached to the
router.
— SCC
For more information about mapping modes, see Appendix C,
Methods and Table Structures" on page 169.
For information on changing map settings, see
Performance Mode (default: 2 Gbps) toggles between 1 Gbps and 2 Gbps.
If set incorrectly and the router is plugged into a Loop or Fabric, the unit may
Override Settings (service mode-restricted access) enhances interoperability
with some storage devices that require special consideration during setup of
the router configuration menus.
— Hi-Sup Bit toggles between Set and Clear.
— Force FCP Response Code toggles between Off and On for support of
HP-specific HBA #223180-B21 and #120186-001.
— Initiator Bit toggles between Set and Clear.
— When using the router in a router-to-router configuration, this option
should be configured to Set. A router-to-router configuration is a type of
configuration where one router appears as a target to another initiator
router.
— Link Garbage Deletion toggles between Enabled and Disabled.
"Mapping Menu" on page 64.
Network Storage Router N1200 User Guide
"Addressing