Table of Contents
Advertisement
Installation
Mounting the SVS 100
The SVS 100 Seamless Video Switcher comes with two sets of mounting brackets.
One set is for mounting the switcher under a table or against a wall, and the other
set is for rack mounting.
Table or wall mounting
The table/wall mounting brackets extend approximately 1/4" (6.3 mm) above the
top surface of the SVS 100 enclosure. This design allows for an air space between
the enclosure and the surface on which it is mounted. Table or wall mount the
switcher as follows:
four #8 screws
on each side
Figure 2-1 — Mounting the SVS 100 Switcher
SVS 100 Installation
2-2
1.
Attach the table/wall mount brackets to the switcher with eight #8
machine screws, provided (see figure 2-1).
rack-mount
bracket
or
table/
wall-mount
bracket
Hold the switcher with the attached brackets against the underside of the
2.
table or other furniture, or against the wall. Mark the location of the
screw holes of the bracket on the mounting surface.
3.
Drill 3/32" (2.4 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the
mounting surface at the marked screw locations.
4.
Insert #8 wood screws into the four pilot holes. Tighten each screw into
the mounting surface until just less than 1/4" of the screw protrudes.
5.
Align the mounting screws with the slots in the brackets and place the
switcher against the surface, with the screws through the bracket slots.
6.
Slide the switcher slightly forward or back, then tighten all four screws to
secure the switcher in place.
two mounting screws
on each side
4
T
P U
IN
IN
3
T
P U
IN
O U
T
IN
2
O U
T
T
IN
P U
IN
IN
T
O U
1
O U
T
T
IN
P U
IN
IN
O U
T
T
O U
Drill pilot holes —
3/32" (2.4mm) diam.
1/4" (6.3 mm) deep
K
O C
N L
G E
T
O U
IN
2 2
/4
3 2
-2
R S
O T
E
M
R E
R
1
L
-
R
+
1
-
+
L
R
-
+
1
-
+
L
-
R
+
1
-
U T
L
+
-
T P
R
+
O U
1
-
L
+
A
-
+
-
C
+
B
Advertisement
Table of Contents
