Table of Contents
Advertisement
Audio Config Page
The MPS 601 audio inputs have three modes that switch the active digital and analog audio
inputs to the output.
Figure 31.
Audio Configuration
Mode 1 (default) – The associated audio input follows the selected input.
•
Audio input A follows input 1.
When input 1 is selected, RGBHV 1 video and audio input A are routed to the HDMI
output.
•
Audio input B follows input 2.
When input 2 is selected, RGBHV 2 video and audio input B are routed to the HDMI
output.
•
When inputs 3, 4, 5, or 6 are selected, the embedded audio of the selected input is
routed to the HDMI output.
Mode 2 – Audio input A is grouped with the analog inputs.
•
When input 1 or input 2 is selected, video from the selected input and audio from
audio input A is routed to the HDMI output.
•
Audio input B is disabled.
•
When inputs 3, 4, 5, or 6 are selected, the selected HDMI video and embedded audio is
routed to the HDMI output.
Mode 3 – Audio input A is grouped with inputs 1, 3, and 5. Audio input B is grouped with
inputs 2, 4, and 6.
•
When input 1 is selected, the selected video and audio input A are routed to the output.
•
When input 2 is selected, the selected video and audio input B are routed to the output.
•
When input 3 or input 5 is selected, the selected HDMI video signal is routed to the
output. If embedded digital audio is present on the HDMI input, it is routed to the
output. If no digital audio is present, audio input A is routed to the output.
•
When input 4 or input 6 is selected, the selected HDMI video signal is routed to the
HDMI output. If embedded digital audio is present on the selected HDMI input, it is
routed to the output. If no digital audio is present, audio input B is routed to the output.
Audio Configuration
MPS 601 • Software Configuration and Control
39
Advertisement
Table of Contents
