HP Console Management Controller User Manual page 68

4-18 Compaq Console Management Controller User Guide
To configure the options:
1. Select whether each fan is installed (available) or not installed
(unavailable).
2. Select the appropriate logic for the alarm relays.
3. Enable the Press
deactivate relay output from the front of the CMC.
4. Select the appropriate options for each lock set.
a. Select whether each lock set is installed (available) or not installed
(unavailable).
b. Select the doors and panels that must be closed before the lock set
can activate the lock.
IMPORTANT: For the door-locking feature to work properly, you must assign at least one
intrusion sensor to each lock set. For more information about configuring intrusion
sensors, see "Sensor Setup Screen" in this chapter.
c. Set the lock sets to remain locked or to unlock in the event of each
listed fault. Enable the concealed door release to press a hidden
switch to manually unlock locked doors.
NOTE: The software cannot detect the concealed door release. Make sure the concealed
door release option is not selected for CMCs that control racks without a concealed door
release.
5. After entering the accessory information, click Save to save the changes
or click Cancel to cancel the changes.
6. Click Return to view the Device Home screen for this CMC. The
Device Home screen is discussed in detail later in this chapter.
to Deactivate Relay option to be able to