Rear View Of The Fibre Channel Router - HP FIBRE CHANNEL TO SCSI ROUTER M8201R Installation And User Manual

Hardware Replacement Procedures
7. Place the old Fibre Channel to SCSI router aside.
8. Install the new Fibre Channel to SCSI router. Refer to section 3
Channel to SCSI Router for the NonStop NS-Series Server
Fibre Channel to SCSI router.
9. Enter in the following SCF command:
SCF> ALTER TAPE TAPE1, WWN 100000E00200F00
The WWN (Worldwide Name) is on the rear of the Fibre Channel to SCSI Router
as shown in
Figure 6-3. Rear View of the Fibre Channel Router
10. Power on the tape drive. See
Then wait for it to perform its power-on-self-test (POST).
11. Start the tape drive in SCF by entering in the following command:
SCF> START TAPE $TAPE1
M8201R Fibre Channel to SCSI Router Installation and User's Guide —529971-005
Figure 6-3 on page 6-3.
WWNN: 100000E00200F000
WWPN: 100000E00C00F000
ENET MAC ID: 00:E0:02:00:00:XY
Figure 6-1
Fibre Channel to SCSI Router Replacement
on page 6-1 for the power switch location.
6 -3
Installing the Fibre
when installing a new
WWN Name
WWP Name
Ethernet MAC ID
(Physical Address)