Table of Contents
Advertisement
Hardware Replacement Procedures
3. Unplug the power cord from the AC power outlet, and then unplug the other end
from the tape drive's AC power receptacle.
4. Disconnect the SCSI cable from port 1 by unscrewing the screws by hand. Do not
use a screwdriver.
5. Disconnect the differential terminator from port 2 by unscrewing the screws by
hand. Do not use a screwdriver.
6. Place the old tape drive aside.
7. Connect the new tape drive. Refer to section 3
Router for the NonStop NS-Series Server
8. Power cycle the Fibre Channel to SCSI router by powering it off and then on.
9. Start the tape drive in SCF by entering in the following command:
SCF> START TAPE $TAPE1
Fibre Channel to SCSI Router Replacement
1. Perform a forced reset on the tape drive in SCF by entering in the following
command:
SCF> RESET TAPE1, FORCED
2. Power off the tape drive by pressing the power switch. See
location.
3. Power off the Fibre Channel to SCSI router.
4. Unplug the power cord from the AC power outlet, and then unplug the other end
from the AC power receptacle on the Fibre Channel to SCSI router.
5. Disconnect the fiber cable from the small form-factor pluggable (SFP) on the unit.
Figure 6-2. Rear View of the Fibre Channel to SCSI Router
AC Power
Receptacle
6. Disconnect the SCSI cable from the Fibre Channel to SCSI router on port 0. If
there is another tape drive connected to port 1, disconnect that device also.
M8201R Fibre Channel to SCSI Router Installation and User's Guide —529971-005
Power
Small Form-Factor
Switch
Pluggable (SFP)
Fibre Channel to SCSI Router Replacement
Installing the Fibre Channel to SCSI
when installing a new tape drive.
Port 0
Port 1
6 -2
Figure 6-1
for the
Advertisement
Table of Contents
