Philips 107E61/00 Service Manual page 57

GENERAL PRODUCT SPECIFICATION
1.0 Introduction
This document is related to the 17" AUTOSCAN (VGA above and Max. resolution
1280X1024 by 60HZ refresh) color monitor for world-wide destination.
General description
2.0
The AUTOSCAN analog color monitor is specified as a display peripheral within
an IBM PC, PS/2 ,VGA and advance VGA compatible system.
The AUTOSCAN analog color monitor is to operate at horizontal line rates
between 30 to 71 KHz and refreshment rate between 50 to 160 Hz, can be applied
to all
RGB analog computers within this scanning frequencies.
The AUTOSCAN analog color monitor is intended to be a finished product,
basically a display device mounted inside a plastic enclosure which provides the
aesthetic mechanical, ergonomic and safety requirements.
General condition
2.1
The unit will produce a usable image after switching-on, measurements are to be
carried out with a full stabilized set after 30 minutes warm-up at room temperature
of 25 C. Repetitive power on/off cycles are allowed though should be avoided
within 4 sec.
Electrical characteristics
3.0
Signal interface
3.1
The AUTOSCAN analog color display has an analog video interface to operates at a
multi-frequencies timing in several display modes.
3.1.1 Input requirements
A. Input signals
Video
Sync.
Polarity : Positive or negative
B. Signal input level
Video : 0.7 Vp-p 75 ohms (for individual of R,G and B signals must not
deviate 0.015 Vp-p from each other for balance of white pattern)
Sync : TTL level
(between 0 and 0.6 V to be considered as low level, between 2.3 and 5.0 V as
high level)
C. Impedance
Video : Terminated with 75 ohms
Sync : Terminated with 4.7K ohms pull down resistors.
17" V32 GS4 107E6-71K CMTR
TYPE
BRAND : PHILIPS
2004-06-11
P.S.SU
: Analog level
: Separate sync. with TTL level
:107E61/00
2004-06-11
8639 000 15582
4
31
590
57
107E6 CRT
Go to cover page