Philips 107E61/00 Service Manual page 13

OSD LOCK
OSD LOCK is a feature which disables the OSD controls. It can be used
when the monitor is set up for demonstration purposes or when
adjustment of the OSD is not desirable.
Switch on OSD LOCK feature:
Press and hold the button continuously for 15 seconds.
Release the button when the message
" CONTROL MENU IS LOCKED" appears.
Switch off OSD lock feature:
Press and hold the button continuously for 15 seconds or until
the message window ''CONTROL MENU IS LOCKED''disappears. And
''MAIN CONTROLS'' appears.
To access factory mode
1. Turn off monitor(don't turn off PC)
2. Press and simultaneously on the front control pane,
then press , wait until the OSD menu with characters
V32 107T6 V0.24 20040303 (below OSD menu) come on the screen
of monitor.
MODEL SELECT MODEL SELECT
3. If OSD menu disappears on the screen of monitor, press
again(anytime), then the OSD menu comes on the screen again.
4. Using : to select OSD menu.
5. Using : to increase or decrease the setting.
6. Using : to access/confirm the selection.
To leave factory mode
7. After alignment of factory mode, turn off monitor(if you do not run
off monitor, the OSD menu is always at the factory mode), then turn
on monitor again (at this moment, the OSD menu goes back to user
mode.)
OSD Adjustments (Continued)
To access BURN IN mode
First of all, monitor displays an image.
1. Disconnect the video cable(interface cable).
2. Turn off monitor
3. Press and simultaneously on the front control panel,
then the BURN IN mode comes on the screen of monitor as below.
50 seconds around
5 second around
repeat
4. Reconnect the video cable, then return the normal image.
SERVICE MODE (indication-factory mode)
00050
MODEL SELECT
107E6 CRT
13
Go to cover page