Remove the modem module cable:
1.
Release the clips (1) built into the base enclosure that secure the RJ-11 jack.
2.
Remove the RJ-11 jack (2) from the clip built into the base enclosure.
3.
Remove the modem module cable (3) from the clips and routing channel built into the base
enclosure.
Reverse this procedure to install the modem module cable.
Power connector cable
NOTE:
The power connector cable is available in the Cable Kit, spare part number 501891-001.
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Switch cover and keyboard (see
d.
Speaker assembly (see
e.
Display assembly (see
f.
Top cover (see
96
Chapter 4 Removal and replacement procedures
Battery on page
52).
Hard drive on page
62).
Optical drive on page
Switch cover and keyboard on page
Speaker assembly on page
Display assembly on page
Top cover on page
84).
55).
74).
76).
69).