Tv Tuner Module Cable - HP PAVILION DV5 Maintenance And Service Manual

Reverse the preceding procedure to install the system board.

TV tuner module cable

NOTE: The TV tuner module cable is available in the Cable Kit, spare part number 501891-001.
Before removing the TV tuner module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Switch cover and keyboard (see
d. Speaker assembly (see
e. Display assembly (see
f. Top cover (see
g. USB board (see
h. System board (see
Remove the TV tuner module cable:
1. Release the clips (1) built into the base enclosure that secure the TV tuner antenna connector.
2. Remove the TV tuner antenna connector (2) from the clip built into the base enclosure.
94 Chapter 4 Removal and replacement procedures
Battery on page 52).
Hard drive on page 62).
Optical drive on page
Switch cover and keyboard on page
Speaker assembly on page
Display assembly on page
Top cover on page 84).
USB board on page 90).
System board on page
55).
74).
76).
92).
69).