Connecting Power - Honeywell HCD5HIH Reference Manual

Connecting Power

Document 800-07067V5 Rev A
07/2013
®
HCD5 equIP Series True Day/Night Network Box Camera Reference Guide
Network RJ-45 Ethernet Connection
The main video connection for your network camera will be made through your Ethernet
network connection. Connect the Ethernet connector on the rear of the camera to your
network using an Ethernet (10Base-T, 100Base-TX) cable.
Note You can connect your camera to a network or connect it directly to a PC or
laptop using a crossover cable.
Caution When connecting a power supply, use a 24 V AC power plug or a PoE
IEEE 802.3 (Power over Ethernet) compatible hub. To avoid damage
to the camera, never connect more than one type of power supply at
the same time.
WARNING! The use of a CSA Certified/UL Listed Class 2 power supply is
required to ensure compliance with electrical safety
standards.
Note Check the power source from the external power supply before applying
power to the camera.
1. Connect the camera to a power supply appropriate for your installation:
• 24 V AC power supply (proceed to
• Power over Ethernet (PoE IEEE 802.3 af) 48 V DC power supply
Note Connect power either from a 24 V AC source or CAT5 Ethernet connector
(PoE). It is not recommended to connect both power sources at the same
time.
step 2)
21