Wiring; Connecting Power - Honeywell HD4DIP Reference Manual

Wiring

Connecting Power

Document 800-04191 Rev A
06/09
Caution When connecting a power supply, use either a 12 VDC or 24 VAC
power plug or use a PoE IEEE 802.3 (Power over Ethernet)
compatible hub. To avoid damage to the camera, never connect more
than one type of power supply at the same time.
WARNING! The use of a CSA Certified/UL Listed Class 2 power supply is
required to ensure compliance with electrical safety standards.
Note Check the power source from the external power supply before applying
power to the camera.
1. Connect the power supply appropriate for your installation:
• 12 VDC or 24 VAC power supply (proceed to
• Power over Ethernet (IEEE 802.3 af) 48 VDC power supply
Note If you are using PoE (802.3 af), power will automatically be supplied to the
camera through the network cable.
2. Connect to the power supply (see
3. Plug the power supply into an appropriate power source. The LED on the RJ45 jack
illuminates to show that the camera is receiving power. If it does not illuminate, check
the terminal block connections and the power source.
Caution When powering the camera from 24 VAC, a UPS source should be
considered to ensure satisfactory performance.
HD4DIP Network Camera V2.1 Reference Guide
step 2)
Figure 2-4 on page 24).
23