Adjusting The Flange Back Focus; Connecting Monitor And Power - Honeywell HCS544 User Manual

Adjusting the Flange Back Focus

The back focus adjustment is accessible at the front end of
the camera housing to adjust the back focal length or
picture focus.
1. Loosen the setscrews with a Phillips screwdriver.
2. Adjust the focus ring to focus the picture.
3. Retighten the setscrew.

Connecting Monitor and Power

Note Check the power source from the external power
supply before applying power to the camera.
1. Connect the VIDEO connector on the rear of the camera
to the video-in connector on your monitor.
2. Connect the camera to a 12 VDC or 24 VAC power
supply (appropriate to your installation). Use a
screwdriver to first loosen the ~AC24V/DC12V terminal
screws on the terminal block.
Figure 3
Power LED
Note To ease installation, the terminal block can be
removed. The power connections of the removable
terminal block are not polarity-sensitive. Connect
either power lead to either connector terminal.
8
Video Connections
E N T E R
+