Table of Contents
Advertisement
Additional scanner and printer setup
5
Remove the small bracket from the system board cage.
Note: Do not discard the screws. These will be used in
6
Install the ISP in the same location where the hard disk was located on the system board.
a
Align the posts of the plastic mounting bracket with the holes on the system board cage, and then press the
bracket on the cage until it clicks into place.
b
Install the ISP on the bracket.
c
Use the provided thumbscrew for the ISP to attach the bracket to the ISP.
Note: Make sure the screws of the ISP are accessible through the ISP opening.
step
12.
41
Advertisement
Table of Contents
