Adjusting The Built-In Clock - A&D UA-1020 Instruction Manual

Adjusting the Built-in Clock

Adjust the clock prior to use.
1. Press the
SET
blinking.
2. Select the year using the
Press the
SET
year and move to month/day selection. The
date can be set anywhere between the years
2010 and 2059.
3. Select the month using the
Press the
SET
month and move to day selection.
4. Select the day using the
Press the
SET
day and move to hour/minute selection.
5. Select the hour using the
Press the
SET
hour and move to minute selection.
6. Select the minute using the
(Press the
SET
setting mode. For details, refer to page 14.)
Press the
START
Note: After three minutes of non-operation, the device
will turn off automatically.
When the clock has not been
set, the clock display indicates
dashes as shown to the right.
When using the device for the first time,
the clock is not adjusted.
When the device is disconnected from the power supply for more than 30
seconds, the set date, time and pressure value will be erased.
When the set date, time and pressure value are erased, please adjust again.
Holding down the
Using the Monitor
button until the year starts
or button.
button to set the current
or
button to set the current
or button.
button to set the current
or
button to set the current
or
button to go to the pressure
button to turn the device off.
or button will change the value continuously.
English 10
button.
button.
button.
Pressing the
button will turn the
device off anytime.
Press
Year
or
Month
Day
or
Hour
Minute
Turn off
Pressure
START
setting mode
or
or
or