D-Link DSL-G604T User Manual page 64

The parameters described in the table below are used to set up filter rules.
Click the Apply button to put the new rule into effect. Any filter rule configured in the menu will appear in the
Filters List with the new settings. The Router must save the new settings and reboot before the new rules are
applied.
Filters Parameters
Source IP
Destination IP
Source Port
Destination Port
Protocol
Action
Page 64 of 110
DSL-G604T Generation II ADSL2+ Wireless Modem Router
Description
For an Outbound Filter, this is the IP address or IP addresses on your LAN for which you
are creating the filter rule. For an Inbound Filter, this is the IP address or IP addresses for
which you are creating the filter rule. You can opt to indicate a
Any IP
from the pull-down menu. Choosing Any IP will apply the rule to all WAN or all LAN
IP addresses depending on which type of rule (Inbound or Outbound) is being configured.
Where the Destination IP address resides also depends on if you are configuring an
Inbound or Outbound filter rule. You can opt to indicate a
from the pull-down menu.
The Source Port is the TCP/UDP port on either the LAN or WAN depending on if you are
configuring an Outbound or Inbound Filter rule. Select one of the following options from
the pull-down menu to define
1024).
The Destination Port is the TCP/UDP port on either the LAN or WAN depending on if you
are configuring an Outbound or Inbound Filter rule. Select one of the following options
from the pull-down menu to define a
(ports above 1024).
Select the transport protocol (
Allow Deny
Select to or
the rule. Packets that are allowed are routed to their destination; packets that are denied
are blocked.
Any Port, Single Port
Any Port, Single Port
TCP UDP TCP/UDP
, or
transport of the data packets according to the criteria defined in
Single IP IP Range
, an
Single IP IP Range
, an
Port Range Safe Range
, or
Port Range Safe Range
, or
) that will be used for the filter rule.
www.dlink.com.au
or
Any IP
or
(ports above