Hardware Installation; Power On Router; Factory Reset Button - D-Link DSL-G604T User Manual

Hardware Installation

The DSL-G604T maintains two separate physical interfaces, an ADSL and an Ethernet interface. Place the
Router in a location where it can be connected to the various devices as well as to a power source. The Router
should not be located where it will be exposed to moisture or excessive heat. Make sure the cables and power
cord are placed safely out of the way so they do not create a tripping hazard. As with any electrical appliance,
observe common sense safety procedures.
The Router can be placed on a shelf or desktop, ideally you should be able to see the LED indicators on the
front if you need to view them for troubleshooting.

Power on Router

CAUTION: The Router must be used with the power adapter included with the device.
To power on the Router:
1. Insert the DC Power Adapter cord into the power receptacle located on the rear panel of the Router and
plug the adapter into a suitable nearby power source.
2. You should see the Power LED indicator light up and remain lit. The Status LED should light solid green and
begin to blink after a few seconds.
3. If the Ethernet port is connected to a working device, check the Ethernet Link/Act LED indicators to make
sure the connection is valid. The Router will attempt to establish the ADSL connection, if the ADSL line is
connected and the Router is properly configured this should light up after several seconds. If this is the first
time installing the device, some settings may need to be changed before the Router can establish a
connection.

Factory Reset Button

The Router may be reset to the original factory default settings by depressing the reset button on the right side
panel (see illustration on page 14) for a few seconds while the device is powered on. Use a ballpoint or
paperclip to gently push down the reset button. Remember that this will wipe out any settings stored in flash
memory including user account information and LAN IP settings. The device settings will be restored to the
factory default IP address 10.1.1.1 and the subnet mask is 255.255.255.0, the default management Username
is "admin" and the default Password is "admin."
Page 15 of 110
DSL-G604T Generation II ADSL2+ Wireless Modem Router
2
www.dlink.com.au