Head.pump-Out - Four winns FUNSHIP Owner's Manual

Bellows Flush Operation:
1... Pull.out.holding.tank.valve.handle.(Figure.J-8).
2... Push.down.on.bellows.to.rinse.the.bowl.
3... Push.valve.handle.all.the.way.in.to.ensure.an.
odor-tight.seal.
Emptying of Portable Models:
1... Empty.when.waste.holding.tank.level.appears.
full.DO.NOT.ALLOW.THE.TANK.TO.BECOME.
OVERFILLED.
2... Make.sure.waste.valve.handle.is.in.the.closed.
position.
3... Remove.fresh.water.tank.from.waste.holding.tank.
(Figure.J-9).
Figure J-9: Removing Fresh Water Tank
4... Remove.waste.holding.tank.from.hold.down..
brackets.
5... Carry.the.waste.holding.tank.to.any.permanent.
toilet.facility..Rotate.the.pour-out.spout.to.the.
desired.position..Remove.the.cap..Depress.the.air.
relief.valve.with.your.thumb.while.emptying.(Figure.
J-10).
Figure J-10: Emptying Waste Holding Tank
6... Rinse.waste.holding.tank.and.recharge.as.de-
scribed.under.preparation.portion.of.this.section.
7. Reassemble unit and fasten to floor or deck.
B. Head Pump Out
The.waste.holding.tank.should.be.emptied.when.
waste.holding.tank.level.gauge.indicator.on.the.porta.
potti.(models.with.pumpout.option.only).has.changed.
Water and Waste Systems - Section J
from.green.to.red.(Figure.J-11).or.when.the.waste.
level indicator for the Vacu-flush system reads .
almost.full..DO.NOT.ALLOW.THE.TANK.TO..
BECOME.OVERFILLED.
Figure J-11: Porta-Potti
If.equipped.with.the.head.pump.out,.the.waste..
can.be.removed.from.the.tank.at.a.pumping.station...
A deck plate fitting labeled WASTE, is provided for
this.purpose..Most.marina.fueling.facilities.provide.
service.for.waste.pump.out..For.waste.holding..
capacities, please refer to the specification sheet,
manufacturer's.literature.and/or.our.website..
To.pump.out.the.holding.tank:
1.. Connect.the.dockside.pump.out.connection.to.the.
WASTE.plate.located.on.the.deck..
NOTICE
Usually the dockside pump out connection
will screw into the waste deck plate or has a
rubber sleeve that inserts into the plate and
must be held in position during the pump out
operation.
2.. Have.the.pumping.station.operator.activate.the.
pumping.equipment..The.waste.will.be.drawn.from.
the.holding.tank.and.into.the.pumping.stations.
disposal.tank.
3.. Remove.the.pump.out.connection.from.the.deck.
plate..Add.1.gallon.of.clean.water.to.the.holding.
tank through the waste deck fitting using a dock-
side.water.hose.
4.. Repeat.steps.1.&.2.above.to.pump.out.the.water.
used in step 3 to flush the holding tank.
5.. Add.waste.holding.tank.treatment.chemical.avail-
able.from.the.dockside.pumping.station.operator.
to.the.head..Flush.at.least.twice..
Be careful when handling and storing treat-
ment chemicals. Not only are they toxic, but
they will also stain and damage surrounding
surface.
Owner's Manual Page