Cisco DPC2425 DOCSIS User Manual page 47

Field Name
Ipsec PassThrough
PPTP PassThrough
Remote Config
Management
Multicast Enable
UPnP Enable
Configuring IP Address Filters
Use the Setup Advanced Settings - IP Filtering page to configure IP address filters.
These filters block a range of IP addresses from accessing the Internet.
4028315 Rev A
How Do I Configure My DOCSIS Residential Gateway?
Description
Checking this box allows applications that use IPSec (IP
Security) to pass through the firewall
Checking this box allows applications that use Point to
Point Tunneling Protocol (PPTP) to pass through the
firewall
Checking this box enables Remote Configuration
Management that allows the user or network operator
to view and/or modify the gateway set-up parameters
from a location on the WAN, as opposed to the LAN
side of the gateway. Access to the set-up parameters is
obtained by using the password to access the
WebWizard.
Enable this feature by checking the Remote Config
Management box on the Setup Advanced Settings -
Options page. To access your gateway from a remote
location, you must also know the WAN IP address of
the gateway. To find the WAN IP address, go to the
Network Configuration page under Basic Settings. You
will find the gateway's WAN IP address list on this
page.
Enter the WAN IP address of your gateway into the
address field of any Web browser using the following
format: http://xxx.xxx.xxx.xxx:8080 where
xxx.xxx.xxx.xxx represents the WAN IP address of your
gateway.
Be sure to follow the syntax exactly, and then click Go
or press Enter. Your gateway Web pages will appear on
the remote computer. You will still need to enter your
password to access the Setup pages of your gateway
Note: If you choose to enable (check) this feature, be
sure to set up a user password to prevent unauthorized
access to your gateway settings.
Checking this box allows multicasts to pass from the
WAN side through to the private network
Checking this box enables Universal Plug and Play
features
47