Cisco DPC2425 DOCSIS User Manual page 37

Field Name
Daylight Saving Time
Time Server
Function Keys
Key
Apply
Add Server
Remove Server
Under normal conditions, you should use the default network settings. In the event
that the network time does not match your local time, or, if your system requires
different settings to operate correctly, you can change the default network settings
using the Setup Basic Settings - Network Configuration page.
Configuring the Network Settings
If you are not familiar with the network configuration procedures detailed in the
following sections, contact your service provider before you attempt to change any
of the residential gateway default network configuration settings.
Click Network Configuration in the Basic Settings section of the Setup page to
access the Setup Basic Settings - Network Configuration page.
4028315 Rev A
How Do I Configure My DOCSIS Residential Gateway?
Description
Allows you to adjust the time during periods
when Daylight Saving Time is in effect. Check the
Enable box to enable or disable this setting.
Note: If the offset for Daylight Savings Time is
other than 60 minutes, enter the offset in the
minutes field.
Add and delete time server URLs or IP addresses
to and from the list, as required. When using
Network Time Protocol, multiple time servers can
be specified for the gateway to query for time of
day. The gateway will sequentially step through
the listed time servers until it acquires the current
time. There are three well known public time
servers entered as default servers.
Description
Saves all additions, edits, and changes
Allows you to add a network time server
Allows you to remove a network time server
37