Attach The Rack-Mount Brackets-Chassis Rear-Mounted - Cisco 7301 Quick Start Manual

Depending on how the rack-mount brackets are attached to the chassis, the chassis either protrudes from the rack or is recessed
in the rack.
Step 1 Locate the rack-mount and cable-management brackets and screws and a Number 2 Phillips screwdriver.
Align the rack-mount bracket (1) to the side of the router. Depending on which set of rack-mount bracket holes you
Step 2
choose to use to attach the rack-mount bracket to the router, the chassis will either be recessed in the rack or protrude
from the rack.
Step 3 Insert and tighten the two screws (2). Repeat Step 1 and Step 2 on the other side of the router.
To install the cable-management bracket, see page 9. If you are not installing the cable-management bracket, skip to
Step 4
the "Four-Post Rack Installation" section on page 8 or the "Two-Post Rack Installation" section on page 9 for
rack-mount instructions.
Attach the Rack-Mount Brackets—Chassis Rear-Mounted
Figure 5 Attaching the Rack-Mount Brackets to the Rear of the Chassis
ATM
GIG ABIT ETH
SLO T 1
ERN ET 0/0
RJ45 EN
TX
CI SC O 73
01
Rack-mount bracket
1
Depending on how the rack-mount brackets are attached to the chassis, it either protrudes from the rack or is recessed in the
rack.
Step 1 Locate the rack-mount brackets and screws and a Number 2 Phillips screwdriver.
Align the rack-mount bracket (1) to the side of the router and insert and tighten the screws (2). Depending on which
Step 2
set of holes on the rack-mount bracket that you use, the router will either be recessed in the rack or protrude from the
rack.
To use the cable-management bracket with the Cisco 7301 router rear-mounted, you must purchase a second
Note
rack-mount kit, attach a rack-mount bracket to the left front of the chassis, and attach the cable-management bracket
to it. See below for cable-management bracket installation instructions.
Go to the "Four-Post Rack Installation" section on page 8 or the "Two-Post Rack Installation" section on page 9.
GIG ABIT ETH
LINK
ERN ET 0/1
GBIC RJ45 EN
GIG ABIT ETH
RX LINK
ERN ET 0/2
TX GBIC RJ45 EN
RX LINK
AUX
CON SOL E
TX GBIC
RX
100 -240 V,
2A, 50/6 0
24V =9A ,
48 - 60V =5A
ALA RM
COM PAC T
FLA SH
STAT US
Hz
4 screws, 8-18 x .37 in., for use with a 19-inch rack
2
4 screws, 8 x .375 in., for use in a 21–23-inch rack
2
1
7