Configure An Auxiliary Port To Receive Console Port Messages; Configure The Native Gigabit Ethernet Interfaces - Cisco 7301 Quick Start Manual

The following sample display includes a continuous listing of all configuration parameters selected in Step 3 through
Step 8. Only IP, IPX, and AppleTalk are the selected protocols for this example.
Configuring global parameters:
Enter host name [Router]: router
The enable secret is a one-way cryptographic secret password used
instead of the enable password when it exists.
Enter enable secret: barney
The enable password is used when there is no enable secret password
and when using older software and some boot images.
Enter enable password: betty
Enter virtual terminal password: fred
Configure SNMP Network Management? [yes]:
Community string [public]:
Configure Vines? [no]:
Configure LAT? [no]:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure DECnet? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure RIP routing? [no]:
Configure CLNS? [no]: n
Configure bridging? [no]:
Configure IPX? [no]: yes
Configure XNS? [no]:
Configure Apollo? [no]:
Step 9 Save your settings to NVRAM. See the "Save the Running Configuration to NVRAM" section on page 28. If you do
not save the configuration settings that you created in the router using configuration mode and the setup facility, your
configuration will be lost the next time you reload the router.

Configure an Auxiliary Port to Receive Console Port Messages

If you choose to have console port messages routed to the auxiliary port, use the IOS command terminal monitor on the
auxiliary port on which you desire to receive console messages.
Router# terminal monitor

Configure the Native Gigabit Ethernet Interfaces

The Cisco 7301 reports both the RJ-45 and Gigabit Ethernet SFP GBIC interface ports as Gigabit Ethernet 0/0, Gigabit Ethernet
0/1, and Gigabit Ethernet 0/2. Before configuring any of the three interfaces, you must first use the media-type interface
command to select the media type, either the SFP GBIC (gbic) or RJ-45 (rj45) port.
The Gigabit Ethernet interfaces on the Cisco 7301 do not support the Inter-Switch Link (ISL) VLAN encapsulation
Note
protocol. We recommend that customers use the IEEE 802.1Q VLAN encapsulation protocol as an alternative. Where
an application requires the use of ISL, this can be provided by the Fast Ethernet or Gigabit Ethernet port adapters.
Note The RJ-45 port is the default media.
22