Operation; Vacuum Cleaning - Royal Dirt Devil EQU Operating Manual

3 Operation

3 Operation

3.1 Vacuum cleaning

8
9
WARNING:
Danger of injury! A damaged appliance must not be
used. Check the cylinder vacuum cleaner and the power
cord each time before using it.
ATTENTION:
Only use the cylinder vacuum cleaner with all filters
intact, in dry condition and correctly placed. Make sure
that the openings of the vacuum cleaner are not
clogged.or obstructed. Otherwise the vacuum cleaner
might be damaged.
NOTE:
Your cylinder vacuum cleaner is equipped with a safety
switch to prevent overheating. It automatically cuts off
the power supply if the motor is overheated. In this case
switch off the vacuum cleaner with the on/off switch
(Fig. 9/1) and pull the plug from the mains socket.
Eliminate the cause of overheating (e g. clogged suction
paths or filters) Wait for about 45 minutes. After it has
cooled off, you may switch on the vacuum cleaner again.
1. Attach the desired nozzle
Chapter 2.3, "Using further nozzles (accessories)".
2. Pull out the power cord by the plug up to the yellow
mark (Fig. 8/1).
WARNING:
Danger of electric shock! If the red marking (Fig. 8/2) is
visible, retract the cord by pressing the retract button
(Fig. 9/2) to pull in the cable up to the yellow mark again.
Otherwise the cord might break.
3. Insert the mains plug into a socket with ground/safety
contact.
4. Switch on the cylinder vacuum cleaner with the on/off
switch (Fig. 9/1). (The green indicator light is on.)
Chapter 2.2, "Assembly" or
27